The K109S is a device that accepts mA/V standard signals. The device can power all 2-wire sensors and all parameters are configurable through dip-switches. The power supply connection is available on the terminals or a special connector (K-BUS) allows a distribution of the power supply to the modules via bus connector. A 3-way galvanic isolation among power supply, input, and output assures the integrity of your data.

Input: Current (0/4 to 20 mA) or Voltage (0/1 to 5, 0/2 to 10 VDC)
Output: Current (0/4-20 mA, 20-4/0 mA) or Voltage (0/1-5, 0/2-10 VDC)
Precision Class: 0.1%

Power Supply:
Channels:
Accuracy:

Status Indicators:


Galvanic Isolation:
Hot Swapping:
Power Consumption:
A/D Converter:
Current Output Protection:
Security Output:

Humidity:
Design:
Filter Rejection:
DIP Switch:

Processing:
Dimensions:
Weight:
Operating Temperature:
Connections:
IP Protection:
Standards:



Approvals:

19.2 to 30 VDC
1 Current or 1 Voltage
0.08% of the f.s. value for mA or 5 V Output
0.07% of the f.s. value for 10 V Output
Input or Output Out-of-Range Limiter Device Triggered
Input Saturation
Internal Fault
Power Supply, Input, and Output at 1500 VAC, Digital
Yes
500 mW
14 bit
Approximately 25 mA
102.5% of Full Scale Value, In Case of Over-Range
105% of Full Scale Value in Case of Improper Functioning
30-90% at +40°C (not condensing)
Terminal Housing for Mounting of 35 mm DIN 46277
50-60 Hz (settable)
Inputs Signal Setup
Output Signal Setup
Floating Point 32 bit
6.2 x 93.1 x 102.5 mm (W x H x D)
50 g
-20 to +65 °C
Plug-in Screw Clamp Terminal Blocks, Wires up to 2.5mm²
IP 20
EN50081-2
EN50082-2
EN61010-1
EN60742
CE, UL-CSA