Z-10-D-OUT is used to drive 10 MOSFETS from all of the control systems which are able to communicate with the transmission protocol MODBUS RTU through the RS485 serial interface. The digital output max load is 0.5 A (inductive) and 0.5 A (resistive) with maximum switch-on/switch-off cycle frequency of 2 cycles/second. The module is ModBUS Slave and can be coupled with any ModBUS Master device. A 3-way galvanic isolation among power supply, output, and RS485 circuits assures the integrity of your data.

Channels: 10 Optoisolated Inputs (10 optoisolated inputs suitable for reed switches, PNP & NPN proximity switches, contact closure. 8 inputs with 16 bit counters at a max frequency of 100 Hz, 2 inputs with 32 bit counters at a max frequency of 10 kHz.)

Power Supply:
Power Consumption:
Isolation:
Input Protection:
Special Functions:


Degree Protection:
Operating Temperature:
Dimensions:
Weight:
Case:
Connections:

Mounting:
Configuration:
Conformity:
Protocol:
Communication Time:
Max Distance:
Max Nodes:

10 to 40 VDC, 19 to 28 VAC 50-60 Hz
2.5 W
1.500 kVAC
400 W/ms
Short circuit diagnostic
On-line configuration
Hot swapping
IP 20
-10 to +65 °C
17.5 x 100 x 112 mm
140 g
PBT, Black
Removable 3-way screw terminals, 3.5 pitch
Rear IDC10 connector for DIN 46277 rail
DIP-switches (baud rate, parity, serial port, bit stop, termination)
Software: Z-NET3, EASY
CE, RINA, UL-CSA, EN 61000-6-4, EN 64000-6-2, EN 61010-1, EN 60742
RS485, ModBUS RTU
< 10 ms (@ 38.4 baud)
1.200 m
64

Type:
Carrying Capacity:
Ext. Power Supply:
Max Rated Current:
Max Rated Voltage:
Max Energy Capability:
MOSFET Time Delay:
Safety Time:
Safety Functions:

10 MOSFET output channels with shared negative pole
0.5 A (inductive/resistive load)
30 VDC
0.5 A
30 VDC
40 mJ with inductive load
5/2 ms
33 ms to 2.184 s
Short circuits protection
Output safety status setting
Measurement of the load power supply voltage